Re: Otterstat question
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Otterstat question



Refer to your parts manual 1:3:1 and you will find the different 
configurations with the vin break at 1233. The reason for the change 
was the concern of an air bubble covering the switch and preventing an 
accurate temp. It appears that if you cut the pipe (101943) to make it 
look like 110131 and replace hose 108675 you can change it to the 
higher vin config. (This is probably what the factory did anyway).
David Teitelbaum
vin 10757


--- In dmcnews@xxxx, deloreanernst@xxxx wrote:
> The otterstat normally faces down, but I saw a couple at Eurofest 
that faced 
> UP. Anyone have a comment on that?
> 
> Wayne A. Ernst 
> DMCTech Group
> 
> 
> 
> [Non-text portions of this message have been removed]






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated