Re: [DML] Fuel system question - electical
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] Fuel system question - electical



>In the 
> workshop manual D:04:14 it states that if a DWELL meter is connected 
> to the Diagnostic plug pin that is connected to terminal 17 of the 
> ECU module (which is the orange wire) I can measure the pulses cycle 
> signal off of it for the Frequency valve. I am doing that I am 
> setting my DWELL meter to a 6-cylinder setting and I am reading it 
> off the scale (high end)! I hear my frequency valve going 

If i remember correctly , from the DMC workshop manual, you need to set your Dwell meter to 4 cylinder to read the frequency valve

> Fuel pressure measured from the center of the fuel distrib (where it 
> goes to the CPR) 75lbs (5 Bar). 

Control Fuel pressure should run from about 20psi(cold) to 55 psi(hot) according to the Technical manual(there is a nice graph to show engine temp in relation to pressure). I had problems with my CPR as it was stuck at 55psi hot or cold. It cost me about $220 to have mine referbished.

Chris
Vin 16327




_______________________________________________________________________
FSmail - Get your free web-based email from Freeserve: www.fsmail.net









Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated