I got a set of high performance ignition wires from Pep-Boys that fit my D. I had the guy cross them over to a Dodge Monaco. Because they were for the PRV, they came with the rubber boots built into the top in order to seal the spark plug wells. But that's were the good news ends. When I purchased the cap and rotor, I had to cross them over to a Borg Warner set. At best all I can say is the cap and rotor fit correctly. The plastic is thinner and lighter. Overall the Borg Warner parts have a more chinsey-er feel to them. On another note, I used to own a '97 Accent. The PCV valve went out on it. I replaced it with a crossover part. 2 months later, the part failed. Went to the dealer and got a factory part. No problems ever again. Lessen learned: If you can find a part which is improved and has a more efficeint function than an OEM unit, consider it. Otherwise never crossover parts, and only buy from the vechile manufacturer. -Robert vin 6585 --- In dmcnews@xxxx, gus@xxxx wrote: <SNIP> > You should contact your Friendly Neighborhood Delorean Parts Vendor.