Had a brainstorm while working on my fuel pump. The rain drain at the center of the windshield louver drains directly onto the fuel pump hoses. A well know design boo boo. I was wondering if anyone has tried wrapping a section of wire loom around the fuel hoses. You know, that split, corrugated tubing that people put over their wiring harnesses. I figure the water would deflect off of the ridges before it can trickle down onto the top of the pump cover. After all, the pump isn't quite under the drain, just the hoses. Couldn't hurt. Anybody tried this? Any thoughts? -Wayne vin 11174