Hey Steve, I recently did the body and frame separation, and I had a list of all the things I had to disconnect/separate to do the separation (list included in this post). Hope that helps some and good luck...it took me 4 1/2 hours to do the actual frame and body separation and if any of you saw me in Cleveland saw the pics I had that showed the body of my car 4 feet in the air on cinder blocks. Later, Nick 1852 Here is the list that I used: Remove 6 body mounting bolts from inside car Remove 2 body mounting bolts from the back of car, Pontoons Remove Engine compartment crossbrace in back of compartment Remove 2 body mounting bolts from front shock towers Remove 2 brake lines from Brake Master Cylinder Remove 1 clutch line from Clutch Master Cylinder Remove Fuel line from Accumulator to Fuel Filter Remove Fuel Filler hose and vent hose Remove All Engine compartment Wiring connections Remove throttle cable from spool Remove all 3 vacuum hoses from Charcoal Canister in LH pontoon wall Remove Gas Fuel Line from Filter to Fuel Distributor Remove Air Conditioner line from Condenser to Evaporator Remove Air Conditioner line from Accumulator to Air Compressor Remove Hoses connected to Heater Core Remove Steering connection to Rack assembly Remove Speedo cable from angle drive to Lambda Service counter Remove Hoses going to heater bottle assembly Remove rear fascia Remove 2 Dust shields under the trailing arms Remove 2 battery cables running inside battery box Remove 2 emergency brake cable running inside car Remove brake power assist vacuum lines from both ends of car Remove vacuum lines to vac reserve can and heater valve Remove oxygen sensor wire Remove ignition fly lead on distributor