Stian - Since you are replacing the window lift mechanism, the best way to remove the old ones and to gain access to the bolts on the window is to cut the old lifts at the elbow. This way you can remove the motor and slide the window down the track. Mike Griese 3335 County Road 15 SW Byron, MN 55920 (507)281-1899 -----Original Message----- From: Stian Birkeland [mailto:dmc_norway@xxxx] Sent: Saturday, July 29, 2000 8:29 AM To: dmcnews@xxxxxxxxxxx Subject: [DML] Removal of window motor assy HELP I just purchased replacement window motor assy's. Here is my story: I have access to everything inside both doors, all panels are removed. And these are my problems: On the passenger side I have rolled the window a bit down so as to get access to the to nuts that hold the window to the worm gear. One of the nuts loosened easily, the other is movable but it is just spinning around. How on earth can I loosen this one???? On the drivers side, the window is stuck in the closed position, meaning that the access to the two nuts on this side is virtually impossible. I cant lower the window enough (read: I cant lower the window at all) and get access to the nuts through the hole in the door. Is there anyway to do a shortcut so that the window will lower? Please respond list, I really need help here! Best wishes Stian Birkeland Norway ________________________________________________________________________ Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com Before posting messages or replies, see the posting policy rules at: www.dmcnews.com/Admin/rules.html To address comments privately to the moderating team, please address: moderator@xxxx