Hi Dave.... I was having problems with my gages a while back. The needles would shake when I turned on the power. I later found that I needed to repair some of the ground wiring. I know that this is a little different from your problem, but I thought I would offer the advice anyway. You might want to check to make sure that the tach is getting the correct amount of current, and that the polarity is correct. I would also check the fuses to make sure that the current one is in place. Hope this helps. If you end up finding a solution, please let me know. Thanks! Dave -----Original Message----- From: Delorean17@xxxx [mailto:Delorean17@xxxx] Sent: Monday, May 29, 2000 6:45 PM To: dmcnews@xxxxxxxxxxx Subject: Re: [DML] New tachometer, still nothing Hello again list, maybe I didnt explain my problem good enough. The tach never moves. when you drive the car it stays at 9000 RPMS even if its in idle. when I put in the new tach and I received no movement from it at all. what could this be? I know it stays at wherever the its at when the car turns off. any ideas? thanks dave Before posting messages or replies, see the posting policy rules at: www.dmcnews.com/Admin/rules.html To address comments privately to the moderating team, please address: moderator@xxxx [Non-text portions of this message have been removed]