--- In dmcnews@xxxxxxxxxxx, "Archie G Hill" <ahelio1@xxxx> wrote: > I need to replace my cluch . I have the > parts. My question is the manual does not address the axles . it tells > how to remove the trans. but does not say anything about what to do with the > axles. Thank you in advance. > > Archie hill Don't take this wrong but if taking the axles off is a problem you should probably not be doing the project. The axles are held in by very obvious bolts through the CV joints to the rear hubs and the transmission output flanges. Just take the bolts out and the axles darn near fall out. Wait until you go to unhook the shift linkage and the small metal cover panels - that's where the fun starts. And the manual is almost no help there either (unless you consider the phrase "disconnect the linkage" a lot of help). Dave Swingle