sgskb-@xxxx wrote: > I have read from other's postings about how the plastic "locater" tabs > break off of the shifter boot and I have tried to re-epoxy mine on. > This seemed to work for a short while and then it broke off again. [snip] > Do any of you have any ideas? I had the same problem. The PO (prior owner) had attempted to hot glue it back together. Unfortunately car interiors can get hotter than the melting point of hot glue. I had a friend that makes fishing lures out of stainless steel wire use the same tools to bend me a new wire frame for the shift boot. I then glued the leather around the wire frame. As part of the frame we formed four tabs that grip under the metal console. It's been holding fine for two years now. I have also seen a steel frame custom-made as part of a replacement boot offered by DeLorean Motor Center in LA. You might be able to buy the frame separately. Dave