[DML] Re: Centering the air meter plate

["endotex23" <endotex23@xxxxxxxxx>]

> --- In dmcnews@xxxxxxxxxxxxxxx, "David Teitelbaum" <jtrealty@xxxx> 
> wrote:
>
> The "rest position" is adjusted by turning the nut next to the hole
for the mixture screw. The plate should be in the center of the
venturi at the smallest point in it's diameter several mm away from
the rubber stop.<

Not to split hairs but technically that is not true. While your
description about the lateral positioning of the plate is correct the
nut you describe only locks the rest pin in one position or permits
adjustment in one direction. The rest position is adjusted by tapping
the pin. Another minor bu timportant point is that it's advisable to
set the final rest position about .015 higher than the top of the
fixed dimension of the venturi throat. Flush is OK but if the plate is
set too low or readjustment is needed after assembly the flow meter
will have to be opened again. I refer you to the Bosch CI service and
overhaul manual for complete details.

Greg








To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/dmcnews/

<*> To unsubscribe from this group, send an email to:
    dmcnews-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/