[DML] HELP: Angle Drive Installation
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[DML] HELP: Angle Drive Installation





1. Instructions for replacement angle drive state that the wheel 
spindle nut is a 32mm and angle drive is 1.25 (inch). What are the 
correct sizes (38mm socket and 1.50 open end)?
2. Any suggestions on replacing the angle drive.
3. I am pulling off the calipers with brake line attached and rotors 
for inspection and clean-up.  What are the torque specs for spindle 
nut and calipers ?  Should I use Locktite for assembly ?
4. Where is the best place to get replacement pads - front and back.

Thanks,
All suggestions are welcomed.
BillG1983
NYDCPA: 09-11-01








To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/dmcnews/

<*> To unsubscribe from this group, send an email to:
    dmcnews-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated