Re: [DML] BLINKERS BLINKERS(driver side)

[Soma576@xxxxxxx]

In a message dated 8/22/04 4:49:37 PM Central Daylight Time, 
john_podlewski@xxxxxxxxx writes:


> Two Blinker Issues: 
>                                #1 My rear driver side blinker does not work 
> at all BULBS AND FUSES GOOD, the passenger rear and front side is fine?
> 

John,
try removing the tail light lens and remove the wiring harness from the 
circuit board.  get some electrical cleaner and douse the circuit board where the 
clip goes on.  rub it in with a towel to get any dirt off the contacts.  on the 
plug, try getting a little wire brush in there so you can soak it in cleaner 
and scrub the contact pins.  once they are clean, use a little allen wrench 
and bend the pins toward the middle of the connector so they will be as tight as 
possible on the board when you reinstall.  i bet the one that goes to the 
blinker is either bent outwards or dirty.  lots of dust can get back there so i 
wouldn't be surprised.  if that still doesn't work, get a multimeter or test 
light and check for +12V off/on/off/on on that pin for the blinker (either 
follow the solder trail from the bulb or check the wire color with your shop 
manual).  what do you find? also check the solder trail on the board for cracks or 
damage.  

if you still have no power back there, contract me off-list and i will assist 
in helping you with a continuity check along the rest of the electrical 
system for the light bulb.


>                                #2 Also the driver front blinker works fine 
> but only WITHOUT the headlights.  When the headlights are on it does not 
> light up at all?  VERY ODD and   the dash gauge for the left blinker is steady, 
> i.e does not blink but is lit.

this one is odd.  I would begin by removing the lens for the blinker and 
checking for damaged wiring or insulation.  you have checked all of your frame 
grounding points and they are all clean and tight, right?  I think the light 
ground is connected to the front subframe/frame extension.  you can view it thru 
the brake master cycliner access cover.  the screw is 10mm and there are maybe 
three other wires at the location.

Andy


[Non-text portions of this message have been removed]




To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/dmcnews/

<*> To unsubscribe from this group, send an email to:
    dmcnews-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/