[DMCForum] Re:CO adjustment

[doctorDHD@xxxxxxx]

Ryan,
 
According to my schematic one of the test connections goes to the +12 volts  
and the other goes to pin 17 on the Lambda ECU.
 
I believe there is a 2 wire connector somewhere below the diagnostic  
connector, that might have gotten loose on you.
 
It looks like Fuse 12 supplies the 12V
 
Dave Delman
aka D² & 6530

Message:  4         
Date: Fri, 3 Feb 2006  17:24:54 -0800
From: Ryan Wright  <ryanpwright@xxxxxxxxx>
Subject: CO adjustment

Where does the  CO adjustment wire (top right corner pin on the
diagnostic connector) go  to? I can't get any signal whatsoever out of
it, so I want to track the  wire down and make sure it isn't  broken
anywhere.

-Ryan



 
Thank  you,

Dave



"Just Say  NO, to the COUCH POTATO!"®


To see how go to _www.tvpedaler.com_ (http://www.tvpedaler.com/)   



[Non-text portions of this message have been removed]

SPONSORED LINKS

Dmc	Dml	Dmc fz10
Dmc fz1s	Delorean part	Dml forte

---

YAHOO! GROUPS LINKS

•  Visit your group "DMCForum" on the web.
   
•  To unsubscribe from this group, send an email to:
   DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---