Re: [DMCForum] Re: Lotsa small spines, or few big spines?

[Martin Gutkowski <martin@xxxxxxxxxxxxxx>]

Because with an identical O/D to start with, smaller splines are 
stronger than larger ones. Just sit down and -think- about it Bill. 
Think about the diameter of the shaft you'd end up with if you machined 
off the sp[lines. Larger splines will result in a smaller shaft once 
machined, therefore the surface covered by the splines is smaller when 
you have larger ones.

So you're not interested in my offer?

You have to ask yourself Bill, if you are the only person to have 
trouble with these "smaller, weaker splines", could it possibly, in all 
likelihood possibly be, something you're doing wrong?

Martin

content22207 wrote:

> I really see no advantage in all those little splines.
>
> Bill Robertson
> #5939

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.