[DMCForum] Re: I don't appear to have a mixture adjustment screw

["ryanpwright" <yahoo1@xxxxxxxxxxxxxx>]

Nevermind, I am a fool. I found it. ;) (I was expecting the screw to
be in that hole, pressing down on the flapper, not mounted on the
flapper itself... Doh!)

-Ryan

--- In DMCForum@xxxxxxxxxxxxxxx, "ryanpwright" <yahoo1@xxxx> wrote:
> Here's a pic of the hole: http://www.ryanwright.com/temp/mixture.jpg
> 
> So I decide to adjust this, since my engine is running a little rich.
> I stick my 3mm allen wrench down in there and it just keeps going. So
> I pull it back out and I hear this "thumpthumpthump". It appears I am
> pushing down a spring loaded flap of some sort when I stick this allen
> wrench in.
> 
> My best guess, pulled straight out of thin air, is that the mixture
> screw is supposed to push down on this flap, preventing it from going
> up too far. Since I appear to have no screw, my flap just comes all
> the way up, thus the engine is very rich.
> 
> Any thoughts?

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.