Re: [DMCForum] A simple trick: New tech article on DMCForum.org

[Martin Gutkowski <martin@xxxxxxxxxxxxxx>]

Um..... You can achieve the same by adding the missing ground connector 
on that relay base, and putting a relay in it. If you don't want it to 
fire all the time, run this ground wire to your switch, then ground it 
on a convenient point, like the feed wire to your handbrake switch, 
directly under where you've put your switch.

Martin

> -----Original Message-----
> From: cruznmd [mailto:racuti1@xxxxxxxxxxxx]
> Sent: Tuesday, May 25, 2004 10:49 PM
> To: DMCForum@xxxxxxxxxxxxxxx
> Subject: [DMCForum] A simple trick: New tech article on DMCForum.org
> 
> I've written a little article on how to wire up your cold-start valve
> to prime your engine on-demand if you have hot start problems from a
> failed accumulator.
> 
> It was more of an exercise in web-authoring that an attempt to reveal
> any hard-core mysteries of the PRV-6. I'm trying to teach myself so I
> can fire up the dmcforum.org website.
> 
> Still, for those who are only lightly mechanically inclined it may
> prove useful. Check it out at: 
> 
> http://www.dmcforum.org/technical/accbypass.htm
> 
> Also, please post any good photos for the newsgroup page to
> the "photos/yahoopage" section and participate in the 3 running polls.
> 
> Thanks!
> 
> Rich A.
> #5335

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.