[DMCForum] Re: Potentially Low Rev'ing PRV (Jim S)

["content22207" <brobertson@xxxxxxxxxxxx>]

This engine was destined for stationary industrial use (to drive a
bilge pump). I have no idea what its operational parameters were.
Internals are obviously standard PRV, but I suppose worst case
scenerio it could have a crazy distributor without counterweights.

You should see the bellhousing and pump shaft coupling...

Bill Robertson
#5939

>--- In DMCForum@xxxxxxxxxxxxxxx, Jim Strickland <ihaveanaccount@xxxx>
wrote:
> 3 to 4,000RPMs?? who the hell never crosses 3000rpm?  
> 
> I'm rarely under 3000rpms unless I'm idling.
> 
> 
>

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.