Re: [DMCForum] nut and bolt supplier to DMC...

[Martin Gutkowski <webmaster@xxxxxxxxxxxxxx>]

It's a bodge, but one way is to mount new rivnuts halfway between the 
old ones, and drill new holes in the rocker panels. It's the way we 
ended up doing it on #2727

Martin

timnagin wrote:

>I would love to have been the supplier to DMC on nuts and bolts.  I finished
>removing everything on the front end today and I swear there was a bolt or
>screw every inch along the way.
>
>Speaking of which, every screw that goes into a rivnut along the driver's
>side plastic rocker panel is spinning in the fiberglass.  Has anyone found a
>good way to get these separated?  On some I can soak them in penetrant, then
>grab the edge of the rivnut with vise grips and get the screw out.  Any
>other suggestions?  What about repairing or replacing these?
>
>Greg
>
>  
>

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.