About reusing original ball joint: I'm not sure if you could remove it without damage. The parameter of the joint has a gear tooth/knurling pattern in it to help it grip in the lower control arm. If the sleeve/hole in the lower control arm is wallowed out, PJ Grady's collar may help tighten it up a bit. It didn't help enough on Tom's car, so we used some pieces from an old feeler gauge as shims. I seem to remember lower ball joints selling for less than $20 each at Advance Discount Autoparts. I have the cross-reference # written down here somewhere. It's the same as an old Volkswagen Beetle. If you splurge on having a vendor send you the "correct" part then have them send you some air for your tires, too. Don't trust that air that you can pick up just anywhere. Support our vendors damn it! Walt Yahoo! Groups Sponsor ADVERTISEMENT <http://rd.yahoo.com/SIG=12cdkllf4/M=267637.4116719.5338353.1261774/D=egro upweb/S=1705126215:HM/EXP=1069656746/A=1853618/R=0/*http://www.netflix.com /Default?mqso=60178338&partid=4116719> click here <http://us.adserver.yahoo.com/l?M=267637.4116719.5338353.1261774/D=egroupm ail/S=:HM/A=1853618/rand=813523642> To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service <http://docs.yahoo.com/info/terms/> .
<<attachment: winmail.dat>>
Back to the Home of PROJECT VIXEN